Time commitments may vary as this is a custom built transmission
SS Mega Monster Transmissions
Engineered to Dominate, the Turbo 400 SS Mega Monster transmission is tough enough to withstand the rigors of even the toughest street machines delivering tire-spinning shifts race after race. It is ideal for vehicles powered by engines producing up to 750 horsepower using pump gasoline. Equipped with a Manual/Automatic valve body, most units allow you to manually shift the vehicle into each gear change or, by placing it in the drive position, remain fully automatic. In either mode, you get a racetrack shift that bangs through the gears giving you all the right to say "Eat My Shift!". When you use the manual gear selection feature, the SS Mega Monster upshifts and downshifts when you move the shift lever, please note, in order to have complete control of the RPM shift timing you must upgrade to a full manual valvebody. When you select the normal drive position, the transmission retains its firm, automatic shifts for the ease of driving you look for in an automatic transmission.
The SS Mega Monster Transmission features: the latest technology in our industry with only the best internal components for increased strength, dependable performance and monster torque capacity. All Monster transmissions are custom made in the USA and quality checked to ensure your peace of mind. For the system to operate properly, all throttle linkage, vacuum lines and kick-down components must be connected and adjusted properly.
OVERHAUL KIT Includes:
New Paper Gaskets, O-rings, Teflon rings
New Rubber Seals for Drums & Pistons
New Steel Check Balls
New Double Lip Seals (Front & Rear)
New Governor Filter
New Kolene Steel Plates
New High Performance Race Clutches
New Brass Washer Kit "NO PLASTIC HERE"
New Bushing Kit
New Torrington Bearing Kit
Superior High Performance Shift Reprogramming Kit
Super Pump
New Pump Bushings
New Stator Bushings, Rotor Gears & Sealing Rings
Modified Boost Valve Assembly
New Boost Valve Spring
New HD 34 Element Sprag
Updated / Modified Accumulators
Heavy Duty Kevlar Bands
High-Temp. Tolerant
Improved Holding Power
Added Strength At Strut Support
Updated & Modified Governor with Spring Kit and Nylon Gear
Recalibrated Valve Body
Recalibrated Shift Plate
New High Flow Filter
New Low / Reverse Heavy Duty Sprag
New Heavy Duty Accumulator Spring
New Modulator
*Special Note: If you are planning a direct transmission swap it is recommended to re-use your existing tail-housing and speedometer gear for your new unit. This Monster 700R4 Transmission does not come equipped with a new Speedometer Gear. Certain vehicle specific tail-housings may not be available with this unit. In most cases, you will be required to swap your original tail-housing (this will NOT void your warranty). Please Contact Us to purchase a proper speedometer gear for your application or if you are unsure if your tail-housing will need to be reused.
.png)
.png)
