Transmission Flush - Dr. Tranny Kooler Kleen Top Product

This convenient oil-based solvent saves time and money for general service and repair shops. It will prevent contaminating new or rebuilt transmissions you install.

FOR PEOPLE WHO DON'T HAVE A
DEDICATED COOLING LINE FLUSHER

A three in one product
The flush can is used to prevent transmission contamination by removing and eliminating contaminants such as grease, dirt, sludge, grime and metal shavings in transmission cooling systems and lines, without leaving any water or soapy residue in the system. It also cleans electric parts, wire harnesses, etc. leaving a thin layer of dielectric protectant.

Benefits

• Leaves no soapy residue


• Won't Harm Seals or Degrade Transmission Fluid
  


• Removes Grease, Sludge, Dirt and Grime
  


• Contains no water


• Prevents contamination


• Prevents costly comebacks


• Contains no ozone depleting chemicals or CFCs


• Contains no chlorinated solvents


• Easy to Use
  

  Directions for Use
  For Line Flush Cleaner: Attach connector to transmission feed line. Next, attach hose to transmission return line to collect flush and residue in a waste container. Hold can upright and actuate. Flush until clear. For best results use entire content of can per installation. Then turn can upside down and continue cleaning with air only.
  For Wire Harness Cleaner: Cut off hose to appropriate length to direct the stream. Spray over dirty depowered 6-12 volt electrical components.
  For Dielectric Protectant: Allow cleaned components to dry before repowering.