Time commitments may vary as this is a custom built transmission
Monster Mega SS Powerglide Recommended for engines producing less than 1800 horsepower and 1900 ft/lbs of torque.
(Vehicles with higher horse power engines check out our other listing here
The Monster SS Powerglide is Engineered to Dominate! This Monster Powerglide will withstand the rigors of even the toughest street machines delivering tire-spinning shifts race after race. It is ideal for vehicle engines producing up to 1800 horsepower and 1900 ft/lbs of torque. Our valve body options will allow you to choose from a race ready trans brake or full manual for the heavy street and strip applications. In either mode, you get all the right to say "Eat My Shift!"
The Monster Powerglide Transmission features: the latest technology in our industry with only the best internal components for increased strength, dependable performance and monster torque capacity. All Monster transmissions are custom made in the USA and quality checked to ensure your peace of mind. For the system to operate properly, all linkage, vacuum lines and components must be connected and adjusted properly.
Certified SFI Performance Reinforced Case
New Performance Master Overhaul Kit
1.80 Straight Cut Gear Set
All New 8 Clutch High Gear Race Clutches
New High Performance Kevlar Lined Band
Newly Upgraded Dual Sealing Ring Servo Kit
NASA Turbo Input shaft
Performance Steel Clutch Hub
Performance Flow Race Prep Pump
Pro Billet Servo Cover
New Deep Aluminum Pan
Newly Upgraded Shift Lever
New High Flow Filter
Comprehensive, Vehicle Installed, Road Race Test
Free Monster Transmission Decals
*Special Note: If you are planning a direct transmission swap it is recommended to re-use your existing tail-housing and speedometer gear for your new unit. This Monster 700R4 Transmission does not come equipped with a new Speedometer Gear. Certain vehicle specific tail-housings may not be available with this unit. In most cases, you will be required to swap your original tail-housing (this will NOT void your warranty). Please Contact Us to purchase a proper speedometer gear for your application or if you are unsure if your tail-housing will need to be reused.